Pocket Card with Cheryl




Hello everyone. 
It's Cheryl here, and today I'm going to show you
how to make a simple pocket card like the one below.

   
 
Begin as you normally would with a regular card size and add your double sided paper to it,
leaving a small border around it.

 
Next, take a matching piece of cardstock to the one you used for your card base. I'm using an A2 sized card, and this is the size cardstock I used for my pocket:
10cm wide x 6.5cm deep
Now take a matching or contrast piece of double sided paper and cut it slightly smaller all the way around, again leaving a border.
Line up your double sided paper and cardstock so they are even at the top, but the double sided paper needs to be centered either side. (See the image below.)

   
 
Make a small mark on the right-hand side on the double sided paper approximately 2.5cm down. You are going to cut from the top left-hand corner down to that small mark on the right. Once you've done that, slide the double sided paper down so there's a border all the way around. (See below.)

 
Glue the double sided paper to the cardstock base, then glue that to your card front on three sides only, leaving the top open.
Don't overdo it with the glue or it will be difficult to add anything into the pocket.
Lastly I added some Ephemera as an embellishment, then added a tag.

  

Products Used:

  Thanks for stopping by today. I hope you enjoyed my creation!  
 

    #artdecocreations   #couturecreationsaus    #ultimatecrafts  




You May Also Like

0 comments

Popular Posts