Telescopic Card with Lee-Anne
Hello all and welcome back to my post for the Couture Creations Design Team.
I am busy with a 6-part workshop series with my craft circle looking at multiple ways of stretching the use of your Dies. In part II of the series, I have been dabbling with making telescopic cards and would like to share this interesting technique with you to make a unique card.
I made this card using the Couture Creations Butterfly Garden paper collection, the Ephemera collection, the Couture Creations mini guillotine, the GoCut and emboss machine and the Couture Creations scoring board.
For this project you will need: 21cmx10.5cm white card, 15cmx10cm gold matt, 14,5cmx10cm pattern 10A, 2x 14cmx9,5cm pattern card 08A (please ensure that the pattern is repeated and the same on both pattern pieces), gold swirl and mini flower die cut from the ephemera collection. Nested oval dies, Foam dots and a collection of die cut flowers, stamens and skeleton leave and a paper sentiment.
The reason you require two pattern pieces the same size and pattern is to create an overlap under each die cut to attach your foam dots. This will create the illusion of the step down or recess. Your pattern also needs to match so that it continues to form part of the recessed area. To cut your nested image, start of by placing the 2ndbiggest nested die on your 1stpattern piece. Place the next two smaller inside the die. This is to ensure a good line-up. Now remove the inside and outside dies, tape down the remaining middle die and run through your go cut and emboss machine to cut. Set aside once cut. This is to cut your top and bottom layers of the recessed area. Not to cut the second die cut, using the 2ndpiece of pattern paper, using the small die cut circle cut out above, place on your card with the die used to cut, ensure that the pattern is matched, remove the die cut paper piece. Place the next two smallest dies onto the pattern to ensure the correct line-up, remove the outer and inner dies, tape up the middle die, and run through you go cut and emboss machine to cut. This is to cut the middle layer of your telescopic recessed area. You will use the large centre die cut circle cut earlier as the base of your recessed telescope. Use the smaller area cut for another project.
To assemble your card, stick the 2ndpattern 10A card to the gold card and then to your white folded card. Using the largest inner die cut earlier and all your layers, check that all line-up with each other with the largest die cut area on the top and stick down the bottom layer. The using your foam dots, stick to the back of the 1stmiddle layer and line-up and stick to the front of your card. Repeat for the top layer adding the foam dots, line up and ensure that your pattern matches and stick down.
Trim the gold swirl and add one piece on top on the left hand side and the other piece just underneath the die cut opening on the right hand side. At the bottom left of your card, continue to add your flowers, stamens, die cut twigs and skeleton leaves, layering on top of each other. Die cut your sentiment and stick to the bottom right of your flowers overlapping the die cut recessed area.
I have included two additional cards using the similar technique, but this time to create a raised telescopic card.
You can watch my video link here:
https://www.youtube.com/watch?v=zUNQJV8fwJE
You can watch my video link here:
https://www.youtube.com/watch?v=zUNQJV8fwJE
Couture Creations Products:
C0726535 12 x 12 Paper – Butterfly Garden - Double Sided paper 09B 710A
C0724824 – Go Cut and Emboss Machine by Couture Creations
C0726540 – Butterfly Garden Die cut Ephemera Set
C0726343 - Couture Creations - Mini Guillotine
C0726428 - Self-adhesive foam dots
Enjoy!
Lea-Anne Alexander
Facebook: @artandcraftcards
#couturecreationsaus
0 comments